Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Dinghy towing

Your vehicle is not designed to be dinghy towed (with 4 wheels on the ground) behind a motor home.

NOTICE

To avoid serious damage to your vehicle

Toyota Sienna. To avoid serious damage to your vehicle


Do not tow your vehicle with four wheels on the ground.

To prevent causing serious damage to the transaxle and Active Torque Control 4WD system (AWD models)

Toyota Sienna. To prevent causing serious damage to the transaxle and Active Torque Control 4WD system


2WD models: Never tow this vehicle from the rear with the front wheels on the ground. This may cause serious damage to the transaxle.

Toyota Sienna. To prevent causing serious damage to the transaxle and Active Torque Control 4WD system


AWD models: Never tow this vehicle with any of the wheels on the ground. This may cause serious damage to the transaxle and Active Torque Control 4WD system.

Trailer towing tips
Your vehicle will handle differently when towing a trailer. Help to avoid an accident, death or serious injury, keep the following in mind when towing: Speed limits for towing a trailer vary by ...

Driving procedures
...

Other materials:

Pressing Power Switch does not Turn on System
INSPECTION PROCEDURE 1 CHECK CABIN Check that conditions in the cabin are not likely to cause condensation. HINT: This problem occurs when the cabin is humid and the temperature rapidly changes. This condition may produce condensation, resulting in a short circuit. OK: Condensation ...

Safety information for Safety Connect
Important! Read this information before using Safety Connect. Exposure to radio frequency signals The Safety Connect system installed in your vehicle is a low-power radio transmitter and receiver. It receives and also sends out radio frequency (RF) signals. In August 1996, the Federal Communi ...

Disassembly
1. INSPECT PACK CLEARANCE OF FORWARD CLUTCH HINT: (See page AX-242) 2. REMOVE FORWARD MULTIPLE DISC CLUTCH DISC (a) Using a screwdriver, remove the snap ring. (b) Remove the flange, 5 discs and 5 plates from the input shaft assembly. 3. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMB ...

В© 2011-2026 Copyright www.tsienna.net