Toyota Sienna 2010-2025 Owners Manual: Driving
- Before driving
- Driving the vehicle
- Cargo and luggage
- Vehicle load limits
- Trailer towing (with towing package)
- Dinghy towing
- Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Engine (ignition) switch (vehicles with a smart key system)
- Automatic transaxle
- Turn signal lever
- Parking brake
- Operating the lights and wipers
- Headlight switch
- Automatic High Beam
- Fog light switch
- Windshield wipers and washer
- Rear window wiper and washer
- Refueling
- Using the driving support systems
- Cruise control
- Dynamic radar cruise control
- Intuitive parking assist
- Rear view monitor system
- Driving assist systems
- PCS (Pre-Collision System)
- BSM (Blind Spot Monitor)
- Driving tips
Canceling the rear moon roof operation (vehicles with the rear
moon roof)
Press the switch to disable the
rear moon roof operation from the
rear seat.
Pressing the switch again will
enable the operation again.
The moon roof can be operated when
The engine switch ...
Before driving
...
Other materials:
Television Display Power Source Circuit
DESCRIPTION
This is the power source circuit to operate the television display assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT TELEVISION DISPLAY ASSEMBLY
Disconnect the connector from the television display
assembly.
Measure the resistance according to the value(s) ...
Reassembly
1. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT
HINT:
Before install the boot, wrap the spline of the outboard
joint shaft with vinyl tape to prevent the boot from
bearing damaged.
(a) Install new outboard joint boot, 2 outboard joint boot
clamps, 2 inboard joint boot clamps and inboard
j ...
Disposal
1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH
HINT:
Dispose the RH side by the same procedures as the LH
side.
(a) Fully extend the shock absorber rod.
(b) Using a drill, make a hole in the cylinder as shown in
the illustration to discharge the gas inside.
CAUTION:
When dril ...
