Toyota Sienna 2010-2026 Owners Manual: Drive information
- Average fuel economy*1, 2 Displays the average fuel consumption since the function was reset.*3
- Tank average fuel economy*1, 2 Displays the average fuel consumption since the vehicle was refueled.
- Trip average fuel economy*1, 2 Displays the average fuel consumption since the engine was started.
- Current fuel economy*1, 2 Displays the current rate of fuel consumption.
- Distance to empty*1 Displays the estimated maximum distance that can be driven with the quantity of fuel remaining.
- This distance is computed based on your average fuel consumption.
As a result, the actual distance that can be driven may differ from that displayed.
- When only a small amount of fuel is added to the tank, the display
may not be updated.
When refueling, turn the engine switch off. If the vehicle is refueled without turning the engine switch off, the display may not be updated.
- Trip distance*1
Displays the driving distance after the engine was started. - Distance*1
Displays the driving distance since the function was reset.*3 - Trip elapsed time*1 Displays the elapsed time since the function was reset.*3
- Elapsed time*1
Displays the elapsed time since the engine was started. - Trip average speed*1 Displays the average vehicle speed since the function was reset.*3
- Average speed*1
Displays the average vehicle speed since the engine was started. - AWD control (if equipped) Displays the torque distribution between the front and rear axles of the AWD control system
- Display off
A blank screen is displayed.
*1: Can be registered to Drive information 1 through 3. *2: Use the displayed fuel consumption as a reference.
*3: Resetting procedures:
- Select a function to be reset using the meter control switches and then press and hold to reset.
- If there is more than one function that can be reset, check boxes will be displayed next to those functions.
Operating the meter control switches
The multi-information display is
operated using the meter control
switches.
Enter/Set
Select an item/Change pages
Return to the previous screen
Press: Displays the screen registered
...
Settings display
The settings of the following items can be changed, refer to
Language
Select to change the language on the display.
Units
Select to change the unit for measure of the fuel consumption and
...
Other materials:
Cooling fan relay
On-vehicle inspection
1. Cooling fan relay
(a) Remove the relay from engine room relay block No.
1.
(b) Measure the resistance of the relay.
Standard resistance
If the result is not as specified, replace the cooling
fan relay.
(c) Install the relay to engine room relay block No. ...
System description
1. MULTIPLEX COMMUNICATION SYSTEM (BEAN)
The BEAN communication line is used to control the
combination meter, the A/C amplifier, the airbag
sensor assembly, the multiplex network body ECU,
the power slide door ECU LH, the power slide door
ECU RH, the power back door ECU, the seat
posi ...
Starting the engine
Shift the shift lever to P and apply the brakes.
Touch the Toyota emblem side
of the electronic key to the
engine switch.
An alarm will sound to indicate that
the start function cannot detect the
electronic key that is touched to the
engine switch if any of the doors is
opened ...
