Toyota RAV4 manuals

Toyota Sienna 2010-2025 Owners Manual: Exhaust gas precautions

Harmful substance to the human body is included in exhaust gases if inhaled.

WARNING

Exhaust gases include harmful carbon monoxide (CO), which is colorless and odorless. Observe the following precautions.

Failure to do so may cause exhaust gases enter the vehicle and may lead to an accident caused by light-headedness, or may lead to death or a serious health hazard.

Important points while driving

  • Keep the back door closed.
  • If you smell exhaust gases in the vehicle even when the back door is closed, open the windows and have the vehicle inspected at your Toyota dealer as soon as possible.

When parking

  • If the vehicle is in a poorly ventilated area or a closed area, such as a garage, stop the engine.
  • Do not leave the vehicle with the engine on for a long time.

    If such a situation cannot be avoided, park the vehicle in an open space and ensure that exhaust fumes do not enter the vehicle interior.

  • Do not leave the engine running in an area with snow build-up, or where it is snowing. If snowbanks build up around the vehicle while the engine is running, exhaust gases may collect and enter the vehicle.

Exhaust pipe

The exhaust system needs to be checked periodically. If there is a hole or crack caused by corrosion, damage to a joint or abnormal exhaust noise, be sure to have the vehicle inspected and repaired by your Toyota dealer.

Child restraint systems with a top tether strap (third seat)
Center seat Secure the child restraint system using the seat belt or LATCH anchors. Adjust the head restraint to the uppermost position. Latch the hook onto the anchor brac ...

Theft deterrent system
...

Other materials:

Installation
1. INSTALL SHIFT LEVER ASSEMBLY (a) Install shift lever assembly to the vehicle with the 4 bolts. Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) NOTICE: Into datum hole of shift lever into datum pin of instrument lower. (b) Connect the 2 connectors to the shift lever assembly. ...

Removal
1. Disconnect cable from negative battery terminal 2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) (See page EC-32) 3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (a) Remove the 2 bolts. (b) Disconnect the 3 exhaust pipe supports and remove the tail exhaust pipe assembly. (c) Remove the gas ...

DTC check / clear
1. USING INTELLIGENT TESTER  Hook up the intelligent tester to the DLC3.  Monitor the ECU data by following the prompts on the tester screen. HINT: intelligent tester has "Snapshot" function which records the monitored data. Please refer to the intelligent tester op ...

В© 2011-2025 Copyright www.tsienna.net