Toyota Sienna 2010-2026 Owners Manual: Heated steering
wheel/seat heaters
Heated steering wheel and seat heaters heat the side grips of the
steering wheel and seats, respectively.
WARNING
- Care should be taken to prevent injury if anyone in the
following categories
comes in contact with the steering wheel and seats when the heater
is on:
- Babies, small children, the elderly, the sick and the
physically challenged
- Persons with sensitive skin
- Persons who are fatigued
- Persons who have taken alcohol or drugs that induce sleep
(sleeping
drugs, cold remedies, etc.)
- Observe the following precautions to prevent minor burns or
overheating:
- Do not cover the seat with a blanket or cushion when using
the seat
heater.
- Do not use seat heater more than necessary.
|
NOTICE
- Do not put heavy objects that have an uneven surface on the seat
and do
not stick sharp objects (needles, nails, etc.) into the seat.
- To prevent battery discharge, do not use the functions when the
engine is
not running.
|
Location of air outlets
The air outlets and air volume
changes according to the
selected air flow mode.
Adjusting the position of the air outlets
Direct air flow to the front or
rear, up or ...
Turns the heated steering wheel
on/off
The indicator light comes on when
the heated steering wheel is operating.
The heated steering wheel can be used when the engine switch is in
IGNITI ...
Other materials:
Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
Refer to the instructions for reassembly of the front
seat assembly (for flat type).
Refer to the instructions for reassembly of the front
seat assembly (for manual seat).
Refer to the instructions for reassembly of the fr ...
Reassembly
1. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
(a) Install the heater radiator unit sub-assembly to the
air conditioning blower assembly.
(b) Install the 2 O-rings to the heater water valve
assembly.
(c) Install the 3 screws and the heater water valve
assembly.
(d) Install the 2 s ...
Removal
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER L ...