Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Washer fluid

Toyota Sienna. Washer fluid


If any washer does not work or the warning message appears on the multi-information display, the washer tank may be empty. Add washer fluid.

WARNING

When refilling washer fluid

Do not refill washer fluid when the engine is hot or running, as washer fluid contains alcohol and may catch fire if spilled on the engine etc.

NOTICE

Do not use any fluid other than washer fluid

Do not use soapy water or engine antifreeze instead of washer fluid.

Doing so may cause streaking on the vehicle’s painted surfaces.

Diluting washer fluid

Dilute washer fluid with water as necessary.

Refer to the freezing temperatures listed on the label of the washer fluid bottle.

Battery
Check the battery as follows: Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. Terminals Hold-down ...

Tires
Replace or rotate tires in accordance with maintenance schedules and treadwear. ...

Other materials:

Installation
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) (See page EC-39) 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Install a new gasket to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 2 nuts. Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf) 3. V V(A) ins ...

Terminals of ECU
1. FOLD SEAT CONTROL ECU LH Disconnect the fold seat control ECU connectors. Measure the voltage and resistance of the wire harness side connectors. If the result is not as specified, there may be a malfunction on the wire harness side.  Reconnect the fold seat control E ...

Installation
1. Install air fuel ratio sensor (for bank 2 sensor 1) (a) Using SST, install the sensor to the exhaust manifold LH. SST 09224-00010 Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST 44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST HINT: Use a torque wrench with a fulcrum ...

© 2011-2026 Copyright www.tsienna.net