Toyota Sienna Service Manual: How to proceed with troubleshooting

Toyota Sienna Service Manual / Engine hood / door / Slide door closer system / How to proceed with troubleshooting

HINT: Troubleshoot in accordance with the procedures on the following pages

1 VEHICLE BROUGHT TO WORKSHOP

2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

3 INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)

Use the intelligent tester to check for normal function of the multiplex communication system.

(ECU unconnected, communication line malfunctioning) Without code outputs, proceed to A.
(ECU unconnected, communication line malfunctioning) With code outputs, proceed to B.

4 PROBLEM SYMPTOMS TABLE

When problem is not listed on problem symptoms table, proceed to A.
When problem is listed on problem symptoms table, proceed to B.

5 PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM

Data List / Active Test.
Terminals of ECU

6 ADJUST, REPAIR OR REPLACE AND RESET SLIDE DOOR SYSTEM

END

Initialization

1. RESET Reset the power slide door system: The power slide door ECU records the fully open position of the power slide door in its memory and the power slide door fully opens and clos ...

Other materials:

Installation
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Install the park/neutral position switch to the manual valve shaft. (b) Temporarily install the 2 bolts. (c) Place a new lock plate and tighten the nut. Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf) (d) Temporarily install the control ...

Folding down the third seats (manual seats)
Before folding the third seats Fold the outside head restraints and lower the center head restraint to the lowest position , and stow the seat belt buckles. Stow the center seat belt. Folding down the third seatbacks Pull the “TO FOLD/LIFT SEATBACK” strap a Return ...

Ignition Coil "A" Primary
HINT: These DTCs indicate malfunctions relating to the primary circuit. If DTC P0351 is set, check the No. 1 ignition coil with igniter circuit. If DTC P0352 is set, check the No. 2 ignition coil with igniter circuit. If DTC P0353 is set, check the No. 3 ignition coil with igniter circ ...