Toyota Sienna Service Manual: Engine hood / door
- Power slide door system
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Initialization
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Inspection procedure
- Slide door closer system
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Back door closer system
- How to proceed with troubleshooting
- Initialization
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Power back door system
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Initialization
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Hood
- Front door
- Slide door
- Slide door lock release motor
- Power slide door main switch
- Power slide door control switch
- Power slide door touch sensor
- Slide door half open stopper control assembly
- Power slide door warning buzzer
- Back door
- Back door opener switch
- Power back door
- Power back door main switch
- Power back door opener / closer switch
- Power back door touch sensor
- Power back door drive unit
- Power back door warning buzzer
- Back door support
- Power slide door control motor and clutch
- Power slide door
- Slide door lock
Lumbar support adjuster assembly
INSPECTION
1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY
Check operation of the lumbar support adjuster
motor.
Check if the lumbar support adjuster moves
smoothly when the ...
Power slide door system
PARTS LOCATION
...
Other materials:
DTC check / clear
1. DTC CHECK (USING SST CHECK WIRE)
Check the DTCs (Present trouble code).
Turn the ignition switch ON, and wait for
approximately 60 seconds.
Using SST, connect terminals TC and CG of the
DLC3.
SST 09843-18040
NOTICE:
Connect the terminals to the correct
positi ...
DSP Error
DTC 44-78 DSP Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
44-78
An error occurs during the decode process (MP3 /
WMA).
-
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs.
NOTICE:
Th ...
Open in Pump Motor Circuit
DTC C1251/51 Open in Pump Motor Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS MOTOR RELAY)
(a) Connect the intelligent tester to the DLC3.
(b) Start the engine.
(c) Select the ACTIVE TEST mode on the intelligent tester.
...
