Toyota Sienna Service Manual: Installation
1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
2. INSTALL RADIO RECEIVER WITH BRACKET (w/ Navigation System)
3. INSTALL RADIO RECEIVER WITH BRACKET (w/o Navigation System)
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
7. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER NO.2
8. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER NO.1
Reassembly
1. INSTALL CENTER CLUSTER MODULE KNOB NO.6
(for Automatic Air Conditioning System)
2. INSTALL CENTER CLUSTER MODULE KNOB NO.5
(for Automatic Air Conditioning System)
3. INSTALL CLOCK ORNAMENT
4. ...
Other materials:
If your vehicle overheats
The following may indicate that your vehicle is overheating.
The needle of the engine coolant temperature gauge
enters the red zone or a loss of engine power is experienced. (For
example, the vehicle speed does not increase.)
The warning message indicating overheats is shown on the
mult ...
Bulb locations
Front
Vehicles without daytime running lights or with bulb type daytime
running lights
Headlight high beam and daytime
running lights (if equipped)
Headlight low beam
(halogen bulb)
Fog light (if equipped)
Front turn signal/parking and
front side marker lights
Vehic ...
Short in Driver Side Squib 2nd Step Circuit
DTC B1180/17 Short in Driver Side Squib 2nd Step Circuit
DESCRIPTION
The driver side squib 2nd step circuit consists of the center airbag sensor
assembly, the spiral cable and
the steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1180/17 is rec ...
