1. INSTALL CENTER CLUSTER MODULE KNOB NO.6 (for Automatic Air Conditioning System)
2. INSTALL CENTER CLUSTER MODULE KNOB NO.5 (for Automatic Air Conditioning System)
3. INSTALL CLOCK ORNAMENT
4. INSTALL PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY (for Automatic Air Conditioning System)
5. INSTALL HEATER BLOWER SWITCH (for Manual Air Conditioning System)
6. INSTALL INTEGRATION CONTROL AND PANEL BULB (for Manual Air Conditioning System)
7. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System)
8. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY (for Manual Air Conditioning System)
9. INSTALL CENTER CLUSTER MODULE KNOB NO.2 (for Manual Air Conditioning System)
10. INSTALL CENTER CLUSTER MODULE KNOB NO.1 (for Manual Air Conditioning System)
Disassembly
InstallationLow pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER
ET-3
2. REMOVE LOW PITCHED HORN
Disconnect the connector.
Remove the bolt and horn.
INSPECTION
1. INSPECT LOW PITCHED HORN
Apply battery voltage and check operation of the
horn, as shown in the table.
Stan ...
Installation
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the park/neutral position switch to the manual
valve shaft.
(b) Temporarily install the 2 bolts.
(c) Place a new lock plate and tighten the nut.
Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
(d) Temporarily install the control ...
Precaution
NOTICE:
When the ignition switch is turned off and the engine
temperature is high, the cooling fans may operate for
approximately 3 minutes.
After turning the ignition switch off, keep hands and
objects away from the fans when they are operating.
HINT:
If al ...