Toyota Sienna Service Manual: Air conditioning
- Air conditioning system (for automatic air conditioning system)
- Precaution
- Parts location
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
- Actuator check
- Air conditioning system (for manual air conditioning system)
- Refrigerant
- Replacement
- Air conditioning unit
- Blower unit
- Blower unit (for rear air conditioning system)
- Blower motor
- Air inlet control servo motor
- Air outlet control servo motor
- Air outlet control servo motor (for rear air conditioning system)
- Air mix control servo motor
- Rear blower resistor
- Compressor and magnetic clutch
- Condenser
- Room temperature sensor
- Room temperature sensor (for rear air conditioning system)
- Ambient temperature sensor
- Evaporator temperature sensor
- Evaporator temperature sensor (for rear air conditioning system)
- Air conditioning pressure sensor
- Magnetic clutch relay
- Heater relay
- Heater relay (for rear air conditioning system)
- Air conditioning control assembly
- Integration control and panel
Installation
1. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY
(a) Install the power steering gear assembly with the 2
bolts and nuts.
Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf)
2. CONNECT PRESSURE ...
Other materials:
When towing full-time 4wd vehicles
Use one of the methods shown below to tow the
vehicle.
If the vehicle has trouble with the chassis or drive
train, use method 1 (flat bed truck).
WHEN TOWING FULL-TIME 4WD VEHICLES
NOTICE: Do not use any towing method other than those shown above.
The towing methods shown b ...
Removal
1. REMOVE ROOF DRIP SIDE FINISH MOULDING
Put protective tape around the roof drip side finish
moulding.
Using a remover for the roof moulding, disengage of
the clips both in the front and rear ends of the roof
drip side finish moulding and then remove the roof
drip side finish moul ...
How to proceed with troubleshooting
The intelligent tester can be used at steps 3, 7, 10, and 13.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
(a) Interview the customer to confirm the trouble.
3 DTC CHECK/CLEAR AND FREEZE FRAME DATA
4 PROBLEM SYMPTOM CONFIRMATION
5 PROBLEM SYMPTOM SIMULATION
6 SYMPTOM SI ...
