Toyota Sienna Service Manual: Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the front seat assembly (for flat type).
- Refer to the instructions for reassembly of the front seat assembly (for manual seat).
- Refer to the instructions for reassembly of the front seat assembly (for power seat).
- Install the front seat inner belt assembly with the
nut.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Inspection
1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
Release the seat belt (Buckle switch is ON).
Check the resistance between the terminals.
Standard
If the result is not as speci ...
Front seat outer belt assembly
COMPONENTS
...
Other materials:
Installation
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the battery negative (-) terminal is
disconnected.
CAUTION:
After disconnecting the negative battery
terminal, wait for at least 90 seconds before
starting the operation.
&n ...
Display check mode
HINT:
This mode checks the color display on the display.
Illustrations may differ from the actual vehicle depending
on the device settings and options. Therefore, some
detailed areas may not be shown exactly the same as on
the actual vehicle.
1. ENTER DIAGNOSTIC MODE
2. D ...
Removal
1. DRAIN ENGINE COOLANT
2. REMOVE V-BANK COVER SUB-ASSEMBLY
3. REMOVE NO. 2 AIR CLEANER INLET
4. REMOVE NO. 1 AIR CLEANER INLET
5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Remove the engine coolant tem ...
