Toyota RAV4 manuals

Toyota Sienna Service Manual: Front seat inner belt assembly

Toyota Sienna Service Manual / Seat belt / Front seat inner belt assembly

COMPONENTS

COMPONENTS

Seat belt warning system
PARTS LOCATION PROBLEM SYMPTOMS TABLE SEAT BELT WARNING SYSTEM ...

Removal
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY HINT:  Refer to the instructions for disassembly of the front seat assembly (for flat type).  Refer to the instructions for disassembly of ...

Other materials:

Removal
1. Remove rear wheel 2. Remove skid control sensor wire (for 2wd) Hint: (see page sp-38) hint: disconnect the rh side by the same procedures as the lh side. 3. SEPARATE SPEED SENSOR REAR LH (for 4WD) HINT: (See page SP-38) 4. SEPARATE SPEED SENSOR REAR RH (for 4WD) HINT: Separate the RH ...

If you have a flat tire (vehicles with a compact spare tire)
Your vehicle is equipped with a spare tire. The flat tire can be replaced with the spare tire. For details about tires: WARNINGIf you have a flat tire Do not continue driving with a flat tire. Driving even a short distance with a flat tire can damage the tire and the wheel ...

Replacement
1. REPLACE GENERATOR DRIVE END FRAME BEARING (a) Remove the 4 screws and retainer plate from the drive end frame. (b) Using SST and a hammer, tap out the drive end frame bearing from the drive end frame. SST 09950-60010 (09951-00250), 09950-70010 (09951-07100) (c) Using SST and a ...

В© 2011-2026 Copyright www.tsienna.net