Toyota Sienna Service Manual: Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
- Install the center rear seat lap type belt assembly
with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the center rear No. 2 seat lap belt assembly
with inner with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the rear No. 2 seat belt assembly inner with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Removal
1. REMOVE CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No. 1 seat assembly (for
center seat).
Remove the bolt an ...
Rear center seat outer belt assembly
COMPONENTS
...
Other materials:
Shift Solenoid "D" Control Circuit
DESCRIPTION
Shifting from 1st to 5th is performed in combination with "ON" and "OFF"
operation of the shift solenoid
valves SL1, SL2, SL3, S4 and SR which are controlled by the ECM. If an open or
short circuit occurs in
either of the shift solenoid valves, the ECM cont ...
Transmitter ID1 Operation Stop
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the
tire and wheel assemblies
measure the air pressures of the tires. The measured values are transmitted to
the tire pressure warning
antenna and receiver on the body as radio waves and then sent to the ti ...
Disassembly
1. REMOVE FRONT SEAT SIDE TABLE LEG COVER (w/
Table)
Using a screwdriver, disengage the claws and
remove the seat side table leg cover.
HINT:
Tape the screwdriver tip before use.
2. REMOVE FRONT SEAT SIDE TABLE (w/ Table)
Remove the 4 nuts and seat side table.
Rem ...
