Toyota Sienna 2010-2026 Owners Manual: Locking the front doors from the outside without a key
- Move the inside lock button to the lock position.
- Close the door.
- Vehicles without a smart key system The doors cannot be locked if either of the front doors is open and the key is in the engine switch.
- Vehicles with a smart key system
The door cannot be locked if the engine switch is in ACCESSORY or
IGNITION ON mode, or the electronic key is left inside the vehicle.
The key may not be detected correctly and the door may be locked.
Unlocking and locking the doors from the inside
Door lock switch
Locks all the doors
Unlocks all the doors
Inside lock button
Locks the door
Unlocks the door
The front doors can be opened
by pulling the inside handle
eve ...
Automatic door locking and unlocking systems
The following functions can be set or cancelled: For instructions on
customizing, refer to
Function
Operation
Shift position linked door
locking function
Shifting the shif ...
Other materials:
Installation
1. INSTALL THROTTLE BODY
Install a new throttle body gasket to the intake air
surge tank.
Install the throttle body with the 4 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Connect the 2 water by-pass hoses.
Connect the throttle body connector and clamp.
2. ...
Oxygen Sensor Heater Control Circuit
HINT:
Sensor 2 refers to the sensor mounted behind the Three-Way Catalytic
Converter (TWC) and located
furthest from the engine assembly.
DESCRIPTION
Refer to DTC P0136 (See page ES-160).
HINT:
When any of these DTCs are set, the ECM enters fail-safe mode. The ECM turns
off the Heated ...
Disassembly
HINT:
When the battery is reconnected, the back door is locked and
cannot be opened. Therefore, it is necessary to unlock the
back door using the door control switch or transmitter switch.
1. REMOVE BACK DOOR SCUFF PLATE (See page ET-
18)
2. REMOVE QUARTER TRIM PANEL ASSEMBLY
FRONT LH
3. REM ...
