Toyota Sienna Service Manual: How to proceed with troubleshooting
The intelligent tester can be used at step 2, 5, 8, 11.
1 Vehicle Brought to Workshop
2 Check and Clear DTCs and Freeze Frame Data
HINT: See page BC-82 and BC-84.
3 Problem Symptom Confirmation
4 Symptom Simulation
5 DTC Check
HINT: See page BC-82.
6 Problem Symptoms Table
HINT: See page BC-79.
7 DTC Chart
HINT: See page BC-88.
8 Circuit Inspection
9 Identification of Problem
10 Repair
11 Confirmation Test
End
System description
1. SYSTEM DESCRIPTION
(a) ABS
(Anti-lock Brake System)
The ABS helps prevent wheels from locking when
the brake is applied firmly or when braking on a
slippery surface.
(b) EBD
(Electronic Brak ...
Calibration
...
Other materials:
On-vehicle inspection
1. CHECK AUTO SLIDE-OPEN / CLOSE FUNCTION
Check that the sliding roof switch can operate the
sliding roof glass as follows while the tilt-up / DOWN
function is not operating.
Standard
HINT:
The sliding roof stops partway when the sliding roof
switch is pushed on either side during AU ...
Inspection
1. INSPECT PRELOAD
(a) Using SST(s) and a torque wrench, check the initial
torque within the backlash range.
SST 09326-20011
Torque: 0.9 to 1.4 N*m (9 to 14 kgf*cm, 8.0 to
12.4 in.*lbf)
HINT:
Use a torque wrench with a fulcrum length of 160
mm (6.30 in.).
(b) Using SST(s) and a torque w ...
Handling of hose clamps
HANDLING OF HOSE CLAMPS
(a) Before removing the hose, check the clamp position
so that it can be reinstalled in the same position.
(b) Replace any deformed or dented clamps with new
ones.
(c) When reusing a hose, attach the clamp on the
clamp track portion of the hose.
(d) For a s ...
