Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Opening the back door from outside the vehicle

Back door opener

Toyota Sienna. Back door opener


Raise the back door while pressing the back door opener to release the lock to open the back door.

Wireless remote control (vehicles with power back door)

Press and hold the switch to open/close the power back door

Toyota Sienna. Wireless remote control


Toyota Sienna. Wireless remote control


Pressing the switch again while the power back door is operating will cause the operation to reverse. However, the reverse operation cannot be performed for the first second after automatic operation starts, even if the wireless remote control switch is pressed again.

Opening/closing the back door from inside the vehicle (vehicles with power back door)
Press and hold the switch to open/ close the back door. Pressing the switch again while the power back door is operating will cause the operation to reverse. However, the reverse operation ...

Power back door switch (if equipped)
Press the switch to close the back door. Pressing the switch again while the power back door is closing will cause it to open again. However, the reverse operation cannot be performed fo ...

Other materials:

Fuel pump resistor
Components REMOVAL 1. REMOVE FUEL PUMP RESISTOR (a) Disconnect the connector. (b) Remove the nut and fuel pump resistor. INSPECTION 1. INSPECT FUEL PUMP RESISTOR (a) Inspect fuel pump resistor. (1) Using an ohmmeter, measure the resistance between the terminals. Standard resi ...

Open in Side Squib RH Circuit
DTC B0111/44 Open in Side Squib RH Circuit DESCRIPTION The side squib RH circuit consists of the center airbag sensor assembly and the front seat side airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B0111/44 is recorded when an open circ ...

SM Solenoid Circuit
DTC C1225/25 SM Solenoid Circuit DESCRIPTION This solenoid turns on when receiving signals the ECU and controls the pressure acting on the wheel cylinders to control the braking force. WIRING DIAGRAM Refer to DTCs C0226/21, C0236/22, C0246/23 and C0256/24 (See page BC-105). INSPECTION PR ...

В© 2011-2026 Copyright www.tsienna.net