Toyota Sienna 2010-2026 Owners Manual: Power back door switch (if equipped)
Press the switch to close the back door.
Pressing the switch again while the power back door is closing will cause it to open again.
However, the reverse operation cannot be performed for the first second after automatic operation starts even if the switch is pressed again.
Opening the back door from outside the vehicle
Back door opener
Raise the back door while
pressing the back door opener
to release the lock to open the
back door.
Wireless remote control (vehicles with power back door)
Press and hold the ...
When closing the back door
Lower the back door using the
back door handle, and make sure
to push the back door down from
the outside to close it. ...
Other materials:
Disassembly
HINT:
When the battery is reconnected, the back door is locked and
cannot be opened. Therefore, it is necessary to unlock the
back door using the door control switch or transmitter switch.
1. REMOVE BACK DOOR SCUFF PLATE (See page ET-
18)
2. REMOVE QUARTER TRIM PANEL ASSEMBLY
FRONT LH
3. REM ...
Voice is not Recognized
INSPECTION PROCEDURE
1 CHECK NAVIGATION SETTINGS
Enter the "Menu" screen by pressing the "MENU" switch.
Select "Setup
Check that "Voice Recognition Guidance" is not OFF.
OK:
Voice Recognition Guidance is not OFF.
2 CHECK MAP DISC
...
Installation
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. INSTALL SIDE AIRBAG SENSOR LH
Check that the ignition switch is off.
Check that the battery negative (-) terminal is
disconnected.
CAUTION:
...
