Toyota Sienna 2010-2026 Owners Manual: Power easy access system
The seat is automatically adjusted to allow the driver to enter and exit the vehicle easily.
When all of the following have been performed, the driver’s seat is automatically adjusted to a position that allows driver to enter and exit the vehicle easily.
- The shift lever has been shifted to P
- The engine switch has been turned off.
- The driver’s seat belt has been unfastened When any of the following has been performed, the driver’s seat will automatically return to their original positions.
- The engine switch has been turned to ACCESSORY mode.
- The driver’s seat belt has been fastened
Operation of the power easy access system
When exiting the vehicle, the power easy access system may not operate if the seat is already close to the rearmost position, etc.
Driving position memory
This feature automatically adjusts the driver’s seat and outside
rear view mirrors to make entering and exiting the vehicle easier
or to suit your preferences. ...
Driving position memory
Your preferred driving position (the position of the driver’s seat and
outside rear view mirrors) can be recalled by pressing a button.
Two different driving positions can be recorded into memor ...
Other materials:
Installation
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
Apply MP grease to the crank arm pivot of the
windshield wiper motor assembly.
Install the windshield wiper motor assembly with the
3 bolts to the windshield wiper link assembly.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
2. INST ...
Installation
1. Install torque converter clutch assembly
(a) Install the torque converter clutch to the automatic
transaxle.
(b) Using vernier calipers and a straight edge, measure
the dimension "A" between the transaxle fitting part
of the engine and the converter fitting part of the
drive ...
Removal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 se ...
