Toyota Sienna Service Manual: Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat).
- Remove the rear seatback board.
- Remove the rear seat shoulder belt cover.
- Remove the 2 bolts, 2 nuts and No. 1 rear seat outer belt assembly.
2. REMOVE 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
- Remove the roof headlining.
HINT: Refer to the instructions for removal of the roof headlining.
- Remove the 2 bolts, 2 nuts and 3 point type No. 2 rear seat belt assembly.
Rear center seat outer belt assembly
COMPONENTS
...
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt in all ...
Other materials:
Child restraint systems with a top tether strap (third seat)
Center seat
Secure the child restraint
system using the seat belt or
LATCH anchors. Adjust the
head restraint to the uppermost
position.
Latch the hook onto the
anchor bracket and tighten
the top tether strap.
Make sure the top tether strap is
securely latched.
...
Open or Short Circuit in ABS Motor Relay Circuit
DESCRIPTION
The ABS motor relay supplies power to the ABS pump motor. While the ABS &
TRAC & VSC are
activated, the ECU switches the ABS motor relay ON and operates the ABS pump
motor.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST USING INTELLIGENT TESTER (AB ...
Parts location
HOW TO PROCEED WITH
TROUBLESHOOTING
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
(a) Confirm problem symptoms.
3 CHECK AND CLEAR DTCS
4 PROBLEM SYMPTOM CONFIRMATION
5 SYMPTOM SIMULATION
6 DTC CHECK (OTHER THAN MULTIPLEX DTC)
7 DTC CHART
8 PROBLEM SYMP ...
