Toyota Sienna Service Manual: DVD-ROM Abnormal

Toyota Sienna Service Manual / Audio / visual / Audio and visual system / Diagnostic trouble code chart / DVD-ROM Abnormal

DTC 44-43 DVD-ROM Abnormal

DESCRIPTION

DTC No.	DTC Detecting Condition	Trouble Area
44-43	DVD-ROM operation is abnormal.	DVD Television display assembly

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK IF A PROPER DVD IS INSERTED

Make sure that the DVD is a video DVD or a CD with an MP3 file, and that it is not deformed, flawed, stained, burred, or otherwise defective.

OK: Normal DVD or CD

HINT:

Translucent or uniquely-shaped DVDs or CDs cannot be played.
For details on playable DVDs or CDs, refer to the Owner's Manual.

2 CHANGE DISC

Replace the disc with another and recheck.

Replace the disc with another normal one.
Clear the DTCs.
Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears

END

Wrong Disc/ Disc cannot be Read

DTC 44-41 Wrong Disc DTC 44-42 Disc cannot be Read DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-41 An unsuitable disc is inserted ...

DVD Error/ Excess Current/ Tray Insertion / Ejection Error

DTC 44-44 DVD Error DTC 44-48 Excess Current DTC 44-50 Tray Insertion / Ejection Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-44 Opera ...

Other materials:

Diagnosis system
DESCRIPTION (a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an intelligent tester (complying with SAE J1987) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read. (b) OBD II regu ...

Front axle hub bolt
COMPONENTS Replacement HINT: Replace the RH side using the same procedures as for the LH side. 1. REMOVE FRONT WHEEL 2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH (See page AH-5) 3. REMOVE FRONT DISC 4. REMOVE FRONT AXLE LH HUB BOLT (a) Temporarily install the 2 nuts and washers ...

Speaker Circuit
DESCRIPTION When the vehicle has a built-in type amplifier, a sound signal is sent from the radio receiver to the speakers via the "6 Speaker System" circuit. When the vehicle has a separate type amplifier, a sound signal from the radio receiver is amplified by ...