Toyota Sienna 2010-2026 Owners Manual: Stowing the third seats (manual seats)
Before stowing or returning third seat, remove any items from the floor area to prevent interference with moving parts.
Before stowing the third seats
- Lower the center head restraint to the lowest position , and stow the seat belt buckles.
- Stow the center seat belt.
Stowing the third seats
- Pull the handle to move the
seat rearward. Then push the
seat down.
The outside head restraints are folded automatically.
- Push the seat against the
floor.
Open the flaps.
Before returning the third seats
Be sure to move the second seats forward from the rearmost position, as they may interfere with the third seats returning operation.
Returning the third seats
- Return the flaps.
Pull the handle and lift up the seat rearward.
- Push the seat forward and
then engage the front leg
locks.
Make sure the front and rear legs are locked securely.
- Raise the seatback and the outside head restraints
Folding down the third seats (power seats)
You can operate the power third seats when the shift lever is in P.
Before folding the third seats
Lower the center head
restraint to the lowest position and stow the
seat belt buckles.
...
Stowing the third seats (power seats)
You can operate the power third seats when the shift lever is in P.
Before stowing or returning third seat, remove any items from the floor
area to prevent interference with moving parts.
Before ...
Other materials:
Reassembly
1. INSTALL FRONT DRIVE SHAFT BEARING
(a) Using SST and a press, install a new front drive
shaft bearing.
SST 09710-30021 (09710-03141), 09527-10011
NOTICE:
Bearing should be completely installed.
2. INSTALL FRONT DRIVE SHAFT RH HOLE SNAP RING
(a) Using a snap ring expander, install a ...
On-vehicle inspection
1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY
(VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
With the curtain shield airbag assembly installed on
the vehicle, perform a visual check. If there are any
defects as mentioned below, replace the front pillar
...
Camshaft Position "A" - Timing Over-Advanced
DTC P0011 Camshaft Position "A" - Timing Over-Advanced
or System Performance (Bank 1)
DTC P0012 Camshaft Position "A" - Timing Over-Retarded
(Bank 1)
DTC P0021 Camshaft Position "A" - Timing Over-Advanced
or System Performance (Bank 2)
DTC P0022 Camshaft Position ...
