Toyota Sienna Service Manual: Test mode procedure

Check that initialization has been completed

(a) Confirm that the data of tire pressure of all tires are displayed on the intelligent tester screen. Tester Display Measurement Item/Range Normal Condition Diagnostic Note ...

Enter test mode

HINT: Operation of the tire pressure warning reset switch can be checked in TEST MODE. During TEST MODE, the system is not initialized by pushing the tire pressure warning reset switch. The ...

Other materials:

Rear evaporator temperature sensor circuit
DESCRIPTION The rear evaporator temperature sensor is installed on the rear evaporator. It detects the rear evaporator temperature. The sensor sends a signal to the A/C amplifier. The resistance of the rear evaporator temperature sensor changes in accordance with the rear evaporator temperatu ...

Reassembly
1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY (a) Apply a light coat of gasoline or spindle oil to the 2 new O-rings, and install it to the fuel pressure regulator. (b) Apply a light coat of gasoline or spindle oil to the 2 O-rings again, and install the fuel pressure regulator to the No. ...

Oxygen (A/F) Sensor Heater Control Circuit
HINT Although the DTC titles say the oxygen sensor, these DTCs relate to the Air-Fuel Ratio (A/F) sensor. Sensor 1 refers to the sensor mounted in front of the Three-Way Catalytic Converter (TWC) and located near the engine assembly. DESCRIPTION Refer to DTC P2195 (See page ES- ...