Toyota RAV4 manuals

Toyota Sienna 2010-2025 Owners Manual: Update contacts from phone

Operation methods differ between PBAP compatible and PBAP incompatible but OPP compatible Bluetooth® phones.

If your cellular phone is neither PBAP nor OPP compatible, the contacts cannot be transferred.

For PBAP Compatible Bluetooth® Phones

  1. Select “Update Contacts from Phone”.
  2. Check that a confirmation screen is displayed when the operation is complete.

    This operation may be unnecessary depending on the type of cellular phone.

    Depending on the type of cellular phone, OBEX authentication may be required when transferring contact data. Enter “1234” into the Bluetooth® phone.

    If another Bluetooth® device is connected when transferring contact data, depending on the phone, the connected Bluetooth® device may need to be disconnected.

    Depending on the type of Bluetooth® phone being connected, it may be necessary to perform additional steps on the phone.

For PBAP Incompatible but OPP compatible Bluetooth® Phones

  1. Select “Update Contacts from Phone”.
  2. Transfer the contact data to the system using a Bluetooth® phone.

    This operation may be unnecessary depending on the type of cellular phone.

    Depending on the type of cellular phone, OBEX authentication may be required when transferring contact data. Enter “1234” into the Bluetooth® phone.

    To cancel this function, select “Cancel”.

  3. Check that a confirmation screen is displayed when the operation is complete.

Updating the contacts in a different way (From the “Call History” screen)

For PBAP compatible Bluetooth® phones, this function is available when “Automatic Transfer” is set to off.

  1. Display the phone screen.
  2. Select the “Call History” tab and select a contact not yet registered in the contact list.
  3. Select “Update Contact”.
  4. Select the desired contact.
  5. Select a phone type for the phone number.
“Contact/Call History Settings” screen
Display the “Phone/Message Settings” screen. Select “Contact/Call History Settings”. Select the desired item to be set. For PBAP compatible Bluetooth® phones, select to ...

Registering a new contact to the contact list
New contact data can be registered. Up to 4 numbers per person can be registered. For PBAP compatible Bluetooth® phones, this function is available when “Automatic Transfer” is set to off. ...

Other materials:

Driving Position Memory Switch Circuit (w/ Memory)
DESCRIPTION The seat memory switch sends signals to the outer mirror control ECU LH via the multiplex communication system to memorize a given seat position. This memory system does not use a position sensor. The seat position is detected by counting pulses that are output when the motor tu ...

Power Slide Door LH does not Operate When Using Inside / Outside Handle
DESCRIPTION  The inside / outside handles have the ability to control operation of the power slide door. Pulling either handle transmits a request signal to the power slide door ECU LH, which then commands the power slide door control motor and clutch to open / close the power sli ...

Evaporator temperature sensor
ON-VEHICLE INSPECTION 1. INSPECT A/C EVAPORATOR TEMPERATURE SENSOR (a) Remove the A/C evaporator temperature sensor (A/ C thermistor). (b) Disconnect the connector from the A/C evaporator temperature sensor (A/C thermistor). (c) Measure the resistance according to the value(s) in the ...

© 2011-2025 Copyright www.tsienna.net