Toyota Sienna 2010-2026 Owners Manual: Using automatic mode
- Press the “AUTO” button (“AUTO” appears on the display).
- Adjust the temperature setting.
- To stop the operation, press the “OFF” button.
Automatic mode indicator
If the fan speed setting or air flow modes are operated, the automatic mode indicator goes off. However, automatic mode for functions other than that operated are maintained.
Air conditioning controls
Adjusting the temperature setting
Press “” on the “TEMP” button to
increase the temperature and “”
to decrease the temperature.
Adjusting the fan speed
Press “” on
to incre ...
Air outlets
Location of air outlets
The air outlets and air volume
changes according to the
selected air flow mode.
Adjusting the position of the air outlets
Direct air flow to the front or
rear, up or ...
Other materials:
Passenger Airbag ON/OFF Indicator Circuit
Malfunction
DTC B1152/28 Passenger Airbag ON/OFF Indicator Circuit
Malfunction
DESCRIPTION
The passenger airbag ON/OFF indicator circuit consists of the center airbag
sensor assembly and
passenger airbag ON/OFF indicator.
This circuit indicates the operation condition of the front passenger airbag,
t ...
Pressure Sensor Circuit
DTC B1423/23 Pressure Sensor Circuit
DESCRIPTION
This DTC is output when refrigerant pressure on the high pressure side is
extremely low (0.19 MPa (2.0
kgf/cm2, 28 psi) or less) or extremely high (3.14 MPa (32.0 kgf/cm2, 455 psi) or
more). The pressure
sensor, which is installed on the pipe ...
Power slide door control switch
INSPECTION
1. INSPECT POWER SLIDE DOOR CONTROL SWITCH
Inspect the resistance of the switch for LH / RH.
Resistance
If the result is not as specified, replace the switch.
Apply battery voltage and check the illuminates.
Standard
If the result is not as specified, replace the ...
