Toyota Sienna 2010-2026 Owners Manual: Vehicle exterior

Toyota Sienna 2010-2026 Owners Manual / Maintenance and care / Maintenance / General maintenance / Vehicle exterior

Items	Check points
Doors	Do the doors operate smoothly?
Engine hood	Does the engine hood lock system work properly?
Fluid leaks	There should not be any signs of fluid leakage after the vehicle has been parked.
Tires	Is the tire inflation pressure correct? The tires should not be damaged or excessively worn. Have the tires been rotated according to the maintenance schedule? The wheel nuts should not be loose.
Windshield wipers/ rear window wiper	The wiper blades should not show any signs of cracking, splitting, wear, contamination or deformation. The wiper blades should clear the windshield/ rear window without streaking or skipping.

WARNING

If the engine is running

Turn the engine off and ensure that there is adequate ventilation before performing maintenance checks.

Vehicle interior

Items Check points Accelerator pedal The accelerator pedal should move smoothly (without uneven pedal effort or catching). Automatic tra ...

Emission inspection and maintenance (I/M) programs

Some states have vehicle emission inspection programs which include OBD (On Board Diagnostics) checks. The OBD system monitors the operation of the emission control system. If the malfunction indic ...

Other materials:

Installation
HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH Install the curtain shield airbag assembly LH with the 13 bolts in the order shown in the illustration. Tor ...

DTC check / clear
1. DTC CHECK Connect the intelligent tester to the DLC3. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3). Turn the ignition switch to the ON posi ...

Disassembly
1. REMOVE FRONT DISC BRAKE BUSH DUST BOOT (a) Using soft jaws on the vise, hold the front disc brake cylinder mounting LH in the vise through aluminum plates. (b) Using a screwdriver and hammer, remove the 2 front disc brake bush dust boots from the front disc brake cylinder mounting LH. ...