Toyota Sienna Service Manual: Air mix control servo motor

Air outlet control servo motor (for rear air conditioning system)

ON-VEHICLE INSPECTION 1. INSPECT REAR AIR OUTLET CONTROL SERVO MOTOR (a) Inspect servo motor operation. (1) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lea ...

For driver side

ON-VEHICLE INSPECTION 1. INSPECT AIR MIX CONTROL SERVO MOTOR (a) Remove the air mix control servo motor. (b) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lea ...

Other materials:

When stopping the engine with the shift lever in a position other than P
If the engine is stopped with the shift lever in a position other than P, the engine switch will not be turned off but instead be turned to ACCESSORY mode. Perform the following procedure to turn the switch off: Check that the parking brake is set. Shift the shift lever to P. Check that t ...

Removal
1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working. 3. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) 4. REMOVE ...

On-vehicle inspection
1. CONNECT INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the intelligent tester. HINT: Please refer to the intelligent tester operator's manual for further details. 2. INSPECT ACTUATOR MOTOR ...