Toyota Sienna Service Manual: DVD-ROM Abnormal

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / DVD-ROM Abnormal

DVD-ROM Abnormal

DESCRIPTION

DTC No.	DTC Detection Condition	Trouble Area
44-43	DVD-ROM operation is abnormal.	DVD Television display assembly

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK IF A PROPER DVD IS INSERTED

Make sure that the DVD is a video DVD or a CD with an MP3 file, and that it is not deformed, flawed, stained, burred, or otherwise defective.

OK: Normal DVD or CD

HINT:

Translucent or uniquely-shaped DVDs or CDs cannot be played.
For details on playable DVDs or CDs, refer to the Owner's Manual.

2 CHANGE DISC

Replace the disc with another and recheck.

Replace the disc with another normal one.
Clear the DTCs.
Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears.

END

Wrong Disc/ Disc cannot be Read

DTC 44-41 Wrong Disc DTC 44-42 Disc cannot be Read DESCRIPTION DTC No. DTC Detection Condition Trouble Area 44-41 An unsuitable disc is inserted DVD ...

DVD Error/ Excess Current/ Tray Insertion / Ejection Error

DTC 44-44 DVD Error DTC 44-48 Excess Current DTC 44-50 Tray Insertion / Ejection Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 44-44 Operation ...

Other materials:

System normal condition check
1. CHECK NORMAL CONDITION If the symptom is applicable to any of the following, it is intended behavior, and not a malfunction. Symptom Answer A longer route than expected is chosen. Depending on the road conditions, the radio and navigation assembly m ...

Installation
1. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH (a) Install the lower ball joint assembly front LH and tighten the nut. Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf) (b) Install a new cotter pin. NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further up to 60°. 2. INS ...

Radio and Navigation Assembly Power Source Circuit
DESCRIPTION This is the power source circuit to operate the radio and navigation assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT RADIO AND NAVIGATION ASSEMBLY Disconnect the radio and navigation assembly connector R15. Measure the resistance according to the value ...