Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Capacity and distribution

Cargo capacity depends on the total weight of the occupants.

(Cargo capacity) = (Total load capacity) - (Total weight of occupants)

Steps for Determining Correct Load Limit

  1. Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs.” on your vehicle’s placard.
  2. Determine the combined weight of the driver and passengers that will be riding in your vehicle.
  3. Subtract the combined weight of the driver and passengers from XXX kg or XXX lbs.
  4. The resulting figure equals the available amount of cargo and luggage load capacity.

    For example, if the “XXX” amount equals 1400 lbs. and there will be five 150 lb passengers in your vehicle, the amount of available cargo and luggage load capacity is 650 lbs. (1400 - 750 (5150) = 650 lbs.)

  5. Determine the combined weight of luggage and cargo being loaded on the vehicle. That weight may not safely exceed the available cargo and luggage load capacity calculated in Step 4.
  6. If your vehicle will be towing a trailer, load from your trailer will be transferred to your vehicle. Consult this manual to determine how this reduces the available cargo and luggage load capacity of your vehicle.
Cargo and luggage
Take notice of the following information about storage precautions, cargo capacity and load: ...

Calculation formula for your vehicle
Cargo capacity Total load capacity (vehicle capacity weight) When 2 people with the combined weight of A lb. (kg) are riding in your vehicle, which has a total load capacity (vehicle cap ...

Other materials:

Front seat frame with adjuster
Inspection 1. INSPECT FRONT SEAT ADJUSTER SUB-ASSEMBLY LH  Check operation of the seat frame (slide motor).  Check if the seat frame moves smoothly when the battery is connected to the slide motor connector terminals. OK If the result is not as specified, replace t ...

Microphone Circuit between Microphone and Radio and Navigation Assembly
DESCRIPTION This circuit sends a microphone signal from the microphone to the radio and navigation assembly. It also supplies power from the radio and navigation assembly to the microphone. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT RADIO AND NAVIGATION ASSEMBLY Measure the v ...

Check for short circuit
(a) If the wire harness is ground shorted (Fig. 5), locate the section by conducting a resistance check with the body ground (below).   (b) Check the resistance with the body ground. (1) Disconnect connectors A and C and measure the resistance. Standard resistance (Fig. 6) HIN ...

© 2011-2026 Copyright www.tsienna.net