Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Casual speech recognization

Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command.

In some situations, it is possible to omit the command for the procedure and directly state the desired operation.

Not all voice commands are displayed in the short cut menu.

This function is available in English, Spanish and French.

Expression examples for each function

Command

Expression examples

“Call <name> <type>” Get me <Robert Brown>.

Call <contacts> <phonetypes>.

“Dial <number>” Call <3334445555>.
Using the voice command system
Press the talk switch. Select to train voice recognition. Select to start the voice recognition tutorial. Select “OK” and say the desired command. On the list screen, ...

Command list
Some recognizable voice commands and their actions are shown below as examples. Basic Command Action “Help” Prompts voice guidance to offer examples of comman ...

Other materials:

Precaution
1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT  Perform the zero point calibration and sensitivity check if any of the following conditions occur.  The occupant classification ECU is replaced.  Accessories (seatback tray and seat cover, etc.) are installed. ...

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) (a) Disconnect the sensor connector. (b) Using SST, remove the sensor from the exhaust manifold. SST 09224-00010 3. REMOVE FRONT EXHAUST PIPE ASSEMBLY (a) Disconnect the heat ...

Installation
1. INSTALL ENGINE OIL COOLER (a) Clean the oil cooler contact surface on the cooler mounting. (b) Install a new O-ring to the oil cooler. (c) Install the oil cooler assembly with the union bolt. Torque: 68 N*m (693 kgf*cm, 50 ft.*lbf) Install the 2 water by-pass hoses with the bolt ...

© 2011-2026 Copyright www.tsienna.net