The compass on the inside rear view mirror indicates the direction in which the vehicle is heading.
On-vehicle inspection
1. INSPECT FRONT AXLE HUB BEARING BACKLASH
(a) Using a dial gauge, check for backlash near the
center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
If backlash exceeds the maximum, replace the
bearing.
NOTICE:
Ensure that the dial gauge is set at right angles
to the measurement surface ...
Number of safety belts and
safety belt buckles
The vehicle is fitted with five safety belts to ensure
occupant safety. However, they can only offer
protection when adjusted correctly.
The two outer safety belt buckles of the rear
seats are intended for the persons sitting on the
left and right.
The center safety belt buckle of the rear seats is ...
Catalyst System Efficiency Below Threshold
MONITOR DESCRIPTION
The ECM uses the sensors mounted in front of and behind the three-way
catalyst (TWC) to monitor its
efficiency. The first sensor, an Air Fuel ratio (A/F) sensor, sends pre-catalyst
A/F ratio information to the
ECM. The second sensor, a heated oxygen sensor (O2S), sends ...