Toyota Sienna 2010-2026 Owners Manual: Correct use of the seat belts

Toyota Sienna 2010-2026 Owners Manual / For safety and security / For safe use / For safety drive / Correct use of the seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle. Use a child restraint system appropriate for the child until the child becomes large enough to properly wear the vehicle’s seat belt.

Adjusting the mirrors

Make sure that you can see backward clearly by adjusting the inside and outside rear view mirrors properly.

WARNING

Observe the following precautions.

Failure to do so may result in death or serious injury.

Do not adjust the position of the driver’s seat while driving.
Doing so could cause the driver to lose control of the vehicle.
Do not place a cushion between the driver or passenger and the seatback.
A cushion may prevent correct posture from being achieved, and reduce the effectiveness of the seat belt and head restraint.
Do not place anything under the front seats.
Objects placed under the front seats may become jammed in the seat tracks and stop the seat from locking in place. This may lead to an accident and the adjustment mechanism may also be damaged.
When driving over long distances, take regular breaks before you start to feel tired.
Also, if you feel tired or sleepy while driving, do not force yourself to continue driving and take a break immediately.

Correct driving posture

Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. Adjust the seat so that you can depress the pedals fully and so ...

Seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle. ...

Other materials:

Problem symptoms table
HINT: Inspect the fuse and relay before confirming the suspected areas in the table below. Inspect each suspected area in numerical order for the corresponding symptom. If the malfunction still exists after checking and confirming that all circuits and components are normal ...

Inspection
1. Inspect generator clutch pulley (a) Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise. If the result is not as specified, replace the clutch pulley. 2. Remove generator drive end frame bearing (a) Check that the bear ...

Installation
1. INSTALL THROTTLE BODY (a) Install a new throttle body gasket to the intake air surge tank. (b) Install the throttle body with the 4 bolts. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) (c) Connect the 2 water by-pass hoses. (d) Connect the throttle body connector and clamp. 2. INSTA ...