Toyota Sienna 2010-2026 Owners Manual: Turning on the high beam headlights
- With the headlights on, push
the lever away from you to turn
on the high beams.
When the light switch is in
position, the Automatic High Beam system will be activated. Pull the lever toward you to the center position to turn the high beams off. - Pull the lever toward you and release it to flash the high beams
once.
You can flash the high beams with the headlights on or off.
Operating instructions
Turning the end of the lever turns on the lights as follows:
The illustration is intended as an example.
U.S.A.
Canada
The headlights, side marker,
parking lights, daytime ...
Manual headlight leveling dial (vehicles with discharge headlights)
The level of the headlight aim can be adjusted according to the number
of passengers and the loading condition of the vehicle.
Raises the level of the headlights
Lowers the level of the hea ...
Other materials:
Assist grips
Type A
An assist grip installed on the ceiling
can be used to support your
body while sitting on the seat.
Type B
An assist grip installed on the pillar
can be used when getting in
or out of the vehicle and others.
WARNING
Type A: Do not use the assist grip when g ...
Registration
1. DESCRIPTION OF CODE REGISTRATION
HINT:
The key has 2 codes: The key code (immobiliser code)
and the wireless code. Both of these codes need to be
registered. Refer to page for the wireless code
registration procedures.
When adding master keys or sub keys (Additional
registration) ...
Installation
1. INSTALL BRAKE ACTUATOR
(a) Install the brake actuator assembly with the 2 nuts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
2. INSTALL BRAKE ACTUATOR WITH BRACKET
(a) Install the actuator with bracket with the 3 bolts.
Torque: 20 N*m (199 kgf*cm, 14 ft.*lbf)
NOTICE:
Be careful not to dam ...
