Toyota Sienna 2010-2026 Owners Manual: Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle.
- Correct use of the seat belts
- Fastening and releasing the seat belt (except for the third center seat)
- Fastening the seat belt (for the third center seat)
- Releasing and stowing the seat belt (for the third center seat)
- Adjusting the seat belt shoulder anchor height (front and second outside Tip-up seats)
- Seat belt pretensioners (front seats)
- Pre-collision seat belts (front seats of vehicles with pre-collision system)
Correct use of the seat belts
Make sure that all occupants are wearing their seat belts before driving
the vehicle. Use a child restraint system appropriate for the child until the child
becomes large enough to properly wear the ...
Correct use of the seat belts
Extend the shoulder belt so that
it comes fully over the shoulder,
but does not come into contact
with the neck or slide off the
shoulder.
Position the lap belt as low as
possible o ...
Other materials:
Short to B+ in Side Squib LH Circuit
DTC B0118/46 Short to B+ in Side Squib LH Circuit
DESCRIPTION
The side squib LH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly LH (side squib LH).
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0118/46 is re ...
On-vehicle inspection
1. INSPECT FUEL CUT RPM
(a) Increase the engine speed to at least 3500 rpm.
(b) Use a sound scope to check for injector operating
sounds.
(c) Check that when the throttle lever is released,
injector operating sounds stop momentarily (at 2500
rpm) and then resume (at 1400 rpm).
Standard
...
How to proceed with
troubleshooting
NOTICE:
DTCs for the CAN communication system are as follows:
U0073, U0100, U0122, U0123, U0124, U0126 and U1101.
HINT:
If U0235 or U1102 is output alone, the CAN communication is
normal
1 CHECK AND CLEAR DTCS
HINT:
CAN communication DTCs are output when there is an
open or short in any ...
