Toyota Sienna 2010-2025 Owners Manual: Do-it-yourself maintenance
- Do-it-yourself service precautions
- Hood
- Positioning a floor jack
- Engine compartment
- Tires
- Tire inflation pressure
- Wheels
- Air conditioning filter
- Wireless remote control/ electronic key battery
- Checking and replacing fuses
- Light bulbs
Emission inspection and
maintenance (I/M)
programs
Some states have vehicle emission inspection programs which
include OBD (On Board Diagnostics) checks. The OBD system
monitors the operation of the emission control system.
If the malfunction indic ...
Do-it-yourself service
precautions
If you perform maintenance yourself, be sure to follow the correct
procedure as given in these sections.
Items
Parts and tools
Battery condition
Warm water
...
Other materials:
Inspection
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
LO Operation Check
Connect the battery (+) to the terminal 1 (+1) of
the connector, the battery (-) to the terminal 5
(E) of the connector, and check that the motor
operates at low speed (LO).
HI Operation Check
...
Installation
1. INSTALL CRANKSHAFT POSITION SENSOR
Apply a light coat of engine oil to the O-ring on the
crankshaft position sensor.
Install the crankshaft position sensor with the bolt.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
Connect the crankshaft position sensor connector.
...
Rear Air Conditioning Relay Circuit
DESCRIPTION
The RR A/C relay is switched on by signals from the A/C amplifier. It
supplies power to the rear blower
motor.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT RELAY (RR A/C)
(a) Remove the RR A/C relay from the No. 3 relay block.
(b) Measure the resistance according to t ...
