Toyota Sienna Service Manual: Removal
1. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).
- Remove the bolt and rear seat 3 point type belt assembly.
2. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for captain seat type).
- Remove the bolt and rear seat 3 point type belt assembly.
3. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type RH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type RH side).
- Remove the bolt and rear seat 3 point type belt assembly.
4. REMOVE REAR SEAT INNER BELT ASSEMBLY
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and rear seat inner belt assembly.
Rear seat inner belt assembly
COMPONENTS
...
Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for reassembly of the rear No. 1
seat assembly (for center seat).
Install the rear seat ...
Other materials:
For automatic air conditioning system
ON-VEHICLE INSPECTION
1. INSPECT AIR INLET CONTROL SERVO MOTOR
(a) Remove the air inlet control servo motor.
(b) Connect the positive (+) lead from the battery to
terminal 4 and negative (-) lead to terminal 5, then
check that the lever turns to "RECIRCULATION"
side smoothly.
...
SRS Warning Light Remains ON
DESCRIPTION
The SRS warning light is located on the combination meter assembly.
When the SRS is normal, the SRS warning light comes on for approximately 6
seconds after the ignition
switch is turned from the LOCK position to ON position, and then goes off
automatically.
If there is a mal ...
Registering a Bluetooth®
audio player for the
first time
To use the Bluetooth® Audio, it is necessary to register an audio
player with the system.
Once the player has been registered, it is possible to use the
Bluetooth® Audio.
For details about registering a Bluetooth® device
Turn the Bluetooth® connection setting of your audio player on ...
