Toyota Sienna Service Manual: Brake control

Installation

1. INSTALL TIRE PRESSURE WARNING RESET SWITCH (a) Engage the 2 claws to install the tire pressure warning reset switch to the lower instrument panel finish panel sub-assembly LH. 2. INSTALL LO ...

Anti-lock brake system

Parts location ...

Other materials:

Inspection procedure
1 BASIC INSPECTION Conditions necessary for the power slide door to open: Power slide door main switch is in the ON position (switch free: orange paint on the top of the switch appears).  Slide door is unlocked (door lock position switch is in the ON position when the slide do ...

No Master/ Connection Check Error
DTC 01-D6 No Master DTC 01-D7 Connection Check Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 01-D6 *1 When either of the following conditions is met:  The component which has stored the code has (had) been disconnected when the ...

Voice Recognition Difficulty
INSPECTION PROCEDURE 1 CHECK CONDITION Check if the system's voice recognition level is low by using only one particular voice. OK: System's voice recognition level is low with any voice. 2 CHECK MAP DISC Check that the map disc is not deformed or cracked. OK: No deformation ...