Toyota Sienna Service Manual: How to proceed with troubleshooting
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
- Interview the customer and confirm the trouble.
- Confirm the problem by duplicating the conditions described by the customer
3 BASIC INSPECTION
- Basic inspection.
- Measure the battery voltage.
Standard voltage: 11 to 14 V
- with Navigation system: Check the power supply to the radio and navigation assembly.
- Turn the ignition switch to the ACC position.
- Check whether the display appears on the radio and navigation assembly.
- without Navigation system: Check the power supply to the radio receiver.
- Turn the ignition switch to the ACC position.
- Check whether the display appears on the radio receiver
4 PROBLEM SYMPTOMS TABLE
- Refer to the problem symptoms table
5 CIRCUIT INSPECTION AND PART INSPECTION
6 IDENTIFICATION OF PROBLEM
7 REPAIR OR REPLACE
8 CONFIRMATION TEST
END
System description
1. OUTLINE
As a unique feature of Rear Seat Entertainment
(RSE) system, the front and rear seat occupants can
enjoy different audio-visual modes at the same time.
Thus, this system o ...
Problem symptoms table
HINT:
Inspect the "Fuse" and "Relay" before confirming the
suspected area as shown in the table below.
DISPLAY FUNCTION:
SOUND FUNCTION:
REMOTE CONTROL FUNCTION:
...
Other materials:
System description
1. DESCRIPTION OF SYSTEM
(a) A tire pressure warning valve and transmitter is
equipped with a tire pressure sensor and a
transmitter and is installed in a tire wheel assembly.
The sensor measures the tire pressure. The
measured value and transmitter ID are transmitted
to the tire pressure wa ...
Data list / active test
HINT:
By accessing the DATA LIST displayed by the intelligent
tester, you can perform such functions as reading the values
of switches and sensors without removing any parts. Reading
the DATA LIST as the first step in troubleshooting is one
method to shorten labor time.
1. DATA LIST FOR OCCUPA ...
Cold Start Idle Air Control System Performance
DESCRIPTION
This monitor will run when the engine is started at -10 to 50°C (14 to 122°F)
of the engine coolant
temperature. The DTC will set after the engine idling for 13 seconds (2 trip
detection logic).
The DTC is designed to monitor the idle air control at cold start. When the
...
