Toyota Sienna Service Manual: Audio / visual
- Audio and visual system
- System diagram
- How to proceed with troubleshooting
- Identification of noise source
- Problem symptoms table
- Terminals of ECU
- DTC check / clear
- Diagnostic trouble code chart
- Rear seat entertainment system
- Radio receiver
- Stereo component amplifier
- Television display
- Radio antenna cord
- Radio antenna pole
- Voltage inverter
- On-vehicle inspection
- Removal
- Inspection
- Video terminal
- Audio terminal
- Steering pad switch
- Window glass antenna wire
- Front No. 1 speaker
- Front No. 2 speaker
- Stereo component speaker
- Rear speaker
- No. 1 Speaker with box
- No. 2 Speaker with box
Engine oil pressure switch
ON-VEHICLE INSPECTION
1. INSPECT ENGINE OIL PRESSURE SWITCH
ASSEMBLY
Disconnect the connector from the oil pressure
switch assembly.
With the switch still installed, measure the
...
Audio and visual system
PARTS LOCATION
SYSTEM DIAGRAM
...
Other materials:
Shift Solenoid "E" Performance (Shift Solenoid
Valve SR)
SYSTEM DESCRIPTION
The ECM uses signals from the vehicle speed sensor to detect the actual gear
position (1st, 2nd, 3rd, 4th
or 5th gear).
Then the ECM compares the actual gear with the shift schedule in the ECM memory
to detect mechanical
problems of the shift solenoid valves, valve b ...
VC Output Circuit
DESCRIPTION
The ECM constantly uses 5 V from the battery voltages supplied to the +B (BATT)
terminal to operate the
microprocessor. The ECM also provides this power to the sensors through the VC
output circuit.
When the VC circuit is short-circuited, the microprocessor in the ECM and
sens ...
Description of initialization
(a) Perform initialization in the following cases:
Before delivery of a new vehicle.
After replacement of the tire pressure warning
ECU*.
After replacement of the tire pressure warning
valve and transmitter.
Specified tire pressure changes depending on
the size or type of the tire.
...
