Toyota Sienna Service Manual: Initialization
1. RESET
- When the back door lock is replaced:
The power back door ECU cannot receive a switch
signal from the lock. This may cause the power
back door system to enter fail-safe mode and DTC
B2215 to set, and also make the system disabled.
When the lock is replaced, be sure to perform the following: first properly connect the lock, second clear the DTC using the intelligent tester and finally recheck that no DTC is output.
- Reset the power back door system:
The power back door ECU records the fully open
position and the fully closed position of the power
back door in its memory and the power back door
fully opens and fully closed based on this memory.
The power back door cannot operate without this memory. In the case where the battery has been removed, manually close the back door fully to reset the power back door system. However, if the battery is removed / installed when the back door is fully open, the power back door operates normally, thus the resetting the system is unnecessary.
Replacing drive unit will also cause the memory of the door positions to be last. Therefore, in such a case resetting the system is necessary.
Reset the power back door system as follows:
- Fully close the power back door if opened.
- Check that the back door fully open and fully close.
- Unlock the power back door using the transmitter switch or the door control switch.
- Turn the ignition switch to the "OFF" position.
- Check that the power back door main switch is in the "ON" position.
- Check that the back door fully open and fully close by pushing the power back door satellite switch or PBD button briefly.
HINT: The jam protection function is enabled through the above initialization procedure.
Customize parameters
HINT:
The following items can be customized.
NOTICE:
After confirming whether the items requested by the
customer are applicable or not for customization,
perform the customize operation.
...
Problem symptoms table
POWER BACK DOOR SYSTEM
Symptom
Suspected Area
Power back door does not operate when switch* is
pressed (* Switch indicates the satellite switch for
power back door)
...
Other materials:
Disposal
HINT:
When scrapping a vehicle equipped with the SRS or
disposing of the front passenger airbag assembly, be sure to
deploy the airbag first in accordance with the procedure
described below. If any abnormality occurs with airbag
deployment, contact the SERVICE DEPT. of the TOYOTA
MOTOR SALES, ...
Control Module Performance
DTC P0607 Control Module Performance
DESCRIPTION
This DTC indicates a malfunction in the ECM.
HINT:
The ECM receives signals from each sensor to control all the functions of the
cruise control with the
microcomputer. When a malfunction is detected, fail-safe remains on until the
ignition sw ...
Diagnostic trouble code chart
1. DTCS FOR AIRBAG SYSTEM
If a malfunction code is displayed during the DTC check,
check the circuit listed for the code in the table below
(Proceed to the page listed for that circuit).
HINT:
When the SRS warning light remains on and the DTC
output is the normal system code, a volta ...
