Toyota Sienna 2010-2026 Owners Manual: Initialization
Items to initialize
The following items must be initialized for normal system operation after such cases as the battery being reconnected, or maintenance being performed on the vehicle.
|
Item |
When to initialize |
| Power sliding door (if equipped) | After reconnecting or changing the battery |
| Power back door (if equipped) | After reconnecting or changing the battery |
| Message indicating maintenance is required (U.S.A. only) | After the maintenance is performed |
| Tire pressure warning system | When changing the tire size |
Customizable features
Settings that can be changed using the audio system screen
Settings that can be changed using the multi-information display
Settings that can be changed by your Toyota dealer
Definition of s ...
Toyota Sienna Service Manual
 ...
Other materials:
Dtc check / clear
1. DTC CHECK (SENSOR CHECK)
(a) After the indicator check is completed, the system
enters the DTC check mode automatically.
(b) Read the codes displayed on the panel. Refer to the
list of codes (See page AC-19) when reading the
codes. (Trouble codes are output at the temperature
display. ...
Problem symptoms table
HINT:
Use the table below to help determine the cause of the
problem symptom. The likely causes of the problem are
indicated in descending order. Check each suspected area
in order. Repair or replace faulty parts or perform
adjustments as necessary.
Inspect the fuse and rel ...
ECM Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
ECM Communication Stop
Mode
"Engine" is not displayed on the "Communication
Bus Check" screen of the intelligent tester
Applies to "ECM Communication Stop Mode" in ...
