Toyota Sienna Service Manual: Installation
1. INSTALL SIDE REAR WINDOW WEATHERSTRIP LH
2. INSTALL QUARTER WINDOW LOCK ASSEMBLY LH
3. INSTALL POWER VENT WINDOW MOTOR ASSEMBLY LH
4. INSTALL SIDE WINDOW ASSEMBLY REAR LH
5. INSTALL RR WINDOW SIDE GARNISH ASSEMBLY LH
6. INSTALL RR WINDOW SIDE GARNISH ASSEMBLY NO.2 LH
7. REMOVE QUARTER TRIM PANEL ASSEMBLY LH
8. INSTALL REAR DOOR SCUFF PLATE LH
9. INSTALL ROOF HEADLINING GARNISH REAR
10. INSTALL BACK DOOR SCUFF PLATE
11. INSTALL ROPE HOOK ASSEMBLY
12. INSTALL REAR DOOR WEATHERSTRIP LH
13. INSTALL REAR NO. 1 SEAT ASSEMBLY LH
HINT:
- Captain seat type
- Center seat type
Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE REAR NO. 1 SEAT ASSEMBLY LH
HINT:
Captain seat type:
Center seat type:
2. REMOVE REAR DOOR WEATHERS ...
Back door glass
COMPONENTS
...
Other materials:
Oxygen (A/F) Sensor Heater Control Circuit
Low/ Oxygen (A/F) Sensor Heater Control Circuit
High
DTC P0031 Oxygen (A/F) Sensor Heater Control Circuit
Low (Bank 1 Sensor 1)
DTC P0032 Oxygen (A/F) Sensor Heater Control Circuit
High (Bank 1 Sensor 1)
DTC P0051 Oxygen (A/F) Sensor Heater Control Circuit
Low (Bank 2 Sensor 1)
DTC P0052 Oxygen (A/F) Sensor Heater Control Circuit
High (Bank 2 S ...
Door LOCK Position Circuit
DESCRIPTION
This circuit detects the state of the door lock detection sensor and send it
to the Multiplex network body
ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 READ VALUE OF INTELLIGENT TESTER
Connect the intelligent tester to DLC3.
Turn the ignition switch ON and push the i ...
Engine hood courtesy
switch
Inspection
1. INSPECT ENGINE HOOD COURTESY SWITCH
Measure the resistance according to the value(s) in
the table below.
Standard resistance
If the result is not as specified, replace the hood lock
assembly. ...
