Toyota Sienna Service Manual: Installation
1. INSTALL FRONT DOOR GLASS WEATHERSTRIP
- Install the front door grass weatherstrip.
2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY (See page MI-45)
3. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY
4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
5. INSTALL BACK FRAME PLATE
6. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY
7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
Removal
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
3. REMOVE FRONT DOOR ARMREST BASE PANEL
ASSEMBLY
4. REMOVE BACK FRAME PLATE
5. REMOVE POWER WINDOW ...
Rear door glass weatherstrip
COMPONENTS
...
Other materials:
Registration
1. DESCRIPTION OF CODE REGISTRATION
HINT:
The key has 2 codes: The key code (immobiliser code)
and the wireless code. Both of these codes need to be
registered. Refer to page for the wireless code
registration procedures.
When adding master keys or sub keys (Additional
registration) ...
Terminals of ecu
Check tire pressure warning ecu
HINT:
Inspect the connectors from the back side while the
connectors are connected.
(a) Disconnect the tire pressure warning antenna and
receiver connector.
(b) Measure the voltage according to the value(s) in the
table below.
(c) Connect the tire pr ...
Installation
1. INSTALL SLIDE DOOR ROLLER ASSEMBLY UPPER
Apply MP grease to the rotating area of the roller.
Install the roller with the 2 bolts.
Torque: 13 N*m (130 kgf*cm, 10 ft.*lbf)
2. INSTALL SLIDE DOOR HINGE ASSEMBLY CENTER LH
Apply MP grease to the rotating areas of the hinge.
Ins ...
