Toyota Sienna Service Manual: Interior

Installation

1. INSTALL BACK DOOR OUTSIDE GARNISH Install the back door outside opener switch with the 2 screws. Install the back door outside garnish with the 5 nuts and a clip. Connect th ...

Front floor footrest

COMPONENTS Removal 1. REMOVE FRONT FLOOR FOOTREST Using a screwdriver, disengage the 2 clips and remove the footrest. HINT: Tape the screwdriver tip before use. Disengage the clips ...

Other materials:

Checking monitor status
The purpose of the monitor result (mode 06) is to allow access to the results for on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalyst, evaporative emission (EVAP) and thermostat. The monitor result allows the OBD II sc ...

Electronic control
(a) REMOVAL AND INSTALLATION OF BATTERY TERMINAL REMOVAL AND INSTALLATION OF BATTERY TERMINAL NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal. (1) Before performing electronic work, disconnect the ...

How to proceed with troubleshooting
HINT: The intelligent tester can be used in steps 2, 3, 4, 6 and 9. 1 VEHICLE BROUGHT TO WORKSHOP 2 CONNECT INTELLIGENT TESTER TO DLC3 HINT: If the display indicates a communication fault in the tester, inspect the DLC3. 3 CHECK DTC AND FREEZE FRAME DATA (a) Check for DTC(s) and freeze f ...