Toyota RAV4 manuals

Toyota Sienna Service Manual: Bluetooth Module Initialization Failed

DTC 57-47 Bluetooth Module Initialization Failed

DESCRIPTION

DTC No.

DTC Detection Condition

Trouble Area

57-47

  • Bluetooth module is not installed.
  •  Problem with Bluetooth module
  •  Problem in communication line to Bluetooth module
Radio and navigation assembly

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 REPLACE RADIO AND NAVIGATION ASSEMBLY

END

Disc cannot be Played/ No Playable Files/ Copyright Protection Error
DTC 44-7D Disc cannot be Played DTC 44-7E No Playable Files DTC 44-7F Copyright Protection Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-7D ...

Gyro Error
DTC 58-10 Gyro Error DTC 80-10 Gyro Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 58-10 Ground short, power supply short, or open circuit in th ...

Other materials:

Reverse Signal Circuit
DESCRIPTION The radio and navigation assembly receives a reverse signal from the park/neutral position switch. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT RADIO AND NAVIGATION ASSEMBLY Disconnect the radio and navigation assembly connector R12.  Measure the voltage accor ...

Camshaft Position "B" - Timing Over
HINT: If DTC P0014, P0015, P0024 or P0025 is present, check the VVT (Variable Valve Timing) system. DESCRIPTION Refer to DTC P0013 (See page ES-87). MONITOR DESCRIPTION DTC P0014 and P0024 The ECM compares current valve timing with target valve timing, while the engine is running a ...

Room light assembly
ON-VEHICLE INSPECTION 1. ROOM LIGHT ASSEMBLY NO.2  Check that the resistance exists between the terminals. Resistance: Below 1 Ω 2. INTERIOR DOME LIGHT SWITCH ASSEMBLY  Check that there is resistance between the terminals at each switch position as shown in the cha ...

В© 2011-2026 Copyright www.tsienna.net