Toyota Sienna 2010-2026 Owners Manual: Location of the spare tire, jack and tools

Toyota Sienna 2010-2026 Owners Manual / When trouble arises / Steps to take in an emergency / If you have a flat tire (vehicles with a compact spare tire) / Location of the spare tire, jack and tools

Toyota Sienna. Location of the spare tire, jack and tools

Spare tire
Jack handle
Tire bag
Jack
Wheel nut wrench
Adapter socket
Tire strap

WARNING

Using the tire jack

Observe the following precautions.

Improper use of the tire jack may cause the vehicle to suddenly fall off the jack, leading to death or serious injury.

Do not use the tire jack for any purpose other than replacing tires or installing and removing tire chains.
Only use the tire jack that comes with this vehicle for replacing a flat tire. Do not use it on other vehicles, and do not use other tire jacks for replacing tires on this vehicle.
Put the jack properly in its jack point.
Do not put any part of your body under the vehicle while it is supported by the jack.
Do not start or run the engine while your vehicle is supported by the jack.
Do not raise the vehicle while someone is inside.
When raising the vehicle, do not put an object on or under the jack.
Do not raise the vehicle to a height greater than that required to replace the tire.
Use a jack stand if it is necessary to get under the vehicle.
When lowering the vehicle, make sure that there is no-one near the vehicle. If there are people nearby, warn them vocally before lowering.

If you have a flat tire (vehicles with a compact spare tire)

Your vehicle is equipped with a spare tire. The flat tire can be replaced with the spare tire. For details about tires: WARNINGIf you have a flat tire Do not continue driving with a fla ...

Taking out the jack and tools

Remove the cover. Remove the adapter socket. Remove the jack. Remove the wheel nut wrench. ...

Other materials:

Reassembly
1. INSTALL RACK STEERING PISTON RING (a) Coat a new O-ring with power steering fluid and install it onto the power steering rack. (b) Expand a new rack steering piston ring with your fingers. NOTICE: Be careful not to over expand the rack steering piston ring. (c) Coat a new rack steer ...

Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY HINT: Refer to the instructions for reassembly of the front seat assembly (for flat type). Refer to the instructions for reassembly of the front seat assembly (for manual seat). Refer to the instructions for reassembly of the fr ...

Open in Driver Side Squib Circuit
DTC B0101/14 Open in Driver Side Squib Circuit DESCRIPTION The driver side squib circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B0101/14 is recorded when an open ...