Toyota Sienna 2010-2025 Owners Manual: When trouble arises
- Essential information
- Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- Fuel pump shut off system
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire (vehicles with run-flat tires)
- If you have a flat tire (vehicles with a compact spare tire)
- If the engine will not start
- If the shift lever cannot be shifted from P
- If the electronic key does not operate properly (vehicles with a smart key system)
- If the battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
Replacing light bulbs
Headlight low beams (halogen bulb)
For left side only: Open the fuse box cover.
Unplug the connector while
pushing the lock release.
Turn the bulb base counterclockwise.
...
Other materials:
Open in Driver Side Squib Circuit
DTC B0101/14 Open in Driver Side Squib Circuit
DESCRIPTION
The driver side squib circuit consists of the center airbag sensor assembly,
the spiral cable and the
steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0101/14 is recorded when an open ...
TS and CG Terminal Circuit
DESCRIPTION
The Test Mode (signal check) circuit detects trouble in the sensor or switch
signal, which cannot be
detected by the DTC check.
Connecting terminals TS and CG of the DLC3 starts the check.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTR ...
Precaution
1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED
IN ACCIDENT
Perform the zero point calibration and sensitivity
check if any of the following conditions occur.
The occupant classification ECU is replaced.
Accessories (seatback tray and seat cover, etc.)
are installed.
...
