Toyota Sienna 2010-2026 Owners Manual: Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- Fuel pump shut off system
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire (vehicles with run-flat tires)
- If you have a flat tire (vehicles with a compact spare tire)
- If the engine will not start
- If the shift lever cannot be shifted from P
- If the electronic key does not operate properly (vehicles with a smart key system)
- If the battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
If your vehicle has to
be stopped in an
emergency
Only in an emergency, such as if it becomes impossible to stop
the vehicle in the normal way, stop the vehicle using the following
procedure:
Steadily step on the brake pedal with both feet and ...
If your vehicle needs to
be towed
If towing is necessary, we recommend having your vehicle
towed by your Toyota dealer or commercial towing service,
using a wheel-lift type truck or flat bed truck.
Use a safety chain system for a ...
Other materials:
Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No .1 seat assembly (for
center seat).
Remove the rear seatback board.
Remove the rear seat shoulder belt cover.
Remove the 2 bolts, 2 nuts and N ...
Evaporative Emission Control System Pressure
DTC P0450 Evaporative Emission Control System Pressure
Sensor / Switch
DTC P0451 Evaporative Emission Control System Pressure
Sensor Range / Performance
DTC P0452 Evaporative Emission Control System Pressure
Sensor / Switch Low Input
DTC P0453 Evaporative Emission Control System Pressure
Sens ...
Disassembly
1. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.1
(a) Remove the 2 screws <C> and defroster nozzle
duct No. 1.
2. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.2
(a) Remove the 2 screws <C> and defroster nozzle
duct No. 2.
3. REMOVE DEFROSTER NOZZLE ASSEMBLY
(a) Remove the 4 screws <C> and d ...
