Toyota Sienna Service Manual: Multiplex communication

Sliding roof switch assembly

ON-VEHICLE INSPECTION 1. INSPECT SLIDING ROOF SWITCH ASSEMBLY Remove the switch. Check the resistance between the terminals when operating the switch. Resistance If the result is no ...

Multiplex communication system

PARTS LOCATION ...

Other materials:

Front wiper rubber
COMPONENTS REMOVAL 1. REMOVE FRONT WIPER BLADE  Remove the front wiper blade from the front wiper arm LH. NOTICE: Do not fold down the front wiper arm with the front wiper blade being removed from it. 2. REMOVE FRONT WIPER RUBBER  Remove the front wiper rubber from th ...

Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat). Remove the rear seatback board.  Remove the rear seat shoulder belt cover.  Remove the 2 bolts, 2 nuts and No. 1 re ...

Initialization
1. RESET When the back door lock is replaced: The power back door ECU cannot receive a switch signal from the lock. This may cause the power back door system to enter fail-safe mode and DTC B2215 to set, and also make the system disabled. When the lock is replaced, be sure to perform t ...