Toyota Sienna Service Manual: How to proceed with troubleshooting
HINT: Troubleshoot in accordance with the procedures on the following pages.
1 VEHICLE BROUGHT TO WORKSHOP
2 DTC CHECK
- Check for DTCs and make a note of the code that is output (See page MP-14).
- Delete the DTC.
- Check if the DTC is output once again when the problem symptom is simulated based on the noted code.
- When no code is output (symptom check and simulation are possible), proceed to A.
- When a code is output, proceed to B.
3 PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
- Terminals of ECU
4 ADJUST, REPAIR OR REPLACE
END
System description
1. MULTIPLEX COMMUNICATION SYSTEM (BEAN)
The BEAN communication line is used to control the
combination meter, the A/C amplifier, the airbag
sensor assembly, the multiplex network body ECU,
...
Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU
Disconnect the G4 ECU connector.
Measure the voltage between the specified
terminals on the wire harness side connector.
If the result is not as ...
Other materials:
Low pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER
ET-3
2. REMOVE LOW PITCHED HORN
Disconnect the connector.
Remove the bolt and horn.
INSPECTION
1. INSPECT LOW PITCHED HORN
Apply battery voltage and check operation of the
horn, as shown in the table.
Stan ...
Disassembly
1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER
(w/ Clearance Sonar System) (See page PM-19)
2. REMOVE NO. 1 ULTRASONIC SENSOR (w/
Clearance Sonar System) (See page PM-19)
3. REMOVE REAR BUMPER ENERGY ABSORBER
4. REMOVE REAR BUMPER BAR PLATE
Remove the 4 clips and the rear bumper bar plate.
5. ...
Automatic transaxle fluid
On-vehicle inspection
1. CHECK FLUID LEVEL
HINT:
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temperature:
70 to 80°C (158 to 176°F)
(a) Park the vehicle on a level surface and set the
parking brake.
(b) With the engine idling and the ...
